Захранващи адаптери, ПоЕ

ПоЕ инжектор за захранване на устройства поддържащи PoE стандарт.

Low-cost passive PoE base unit for powering passive PoE devices over ethernet. Simply connect your power source to the injector, and then use an ethernet cable to connect the injector to the RouterBOARD device. Helps reducing number of wires that lead up the tower, and in other situations.

For using with RouterBOARDS that support 10-28V PoE powering, input needs to be at least 18V to accomodate any losses in cables.

• тип - понижаващ;
• входно напрежение - 12V - 36V DC;
• изходно напрежение - 3.3V - 24V DC;
• максимален ток: 5А, 75W

Onboard voltmeter auto-calibration method:
1. Onboard voltmeter shows that the output voltage, long press the right button 2 seconds to loosen, voltmeter, and the output voltage indicator light "OUT" synchronous flash, at this time into the output voltage regulation mode;Similarly, when the input voltage IN the voltmeter display, long press the right button 2 seconds to loosen, voltmeter, and the input voltage indicator light "IN" synchronous flash, at this time into the input voltage adjustment mode;
2. Touch the right key, the voltage of a unit, a light touch on the left key, voltage reduce a unit;Due to a unit of voltage is less than 0.1 V, so you need to press the 1-5 consecutive can see the voltmeter change 0.1 V, the concrete continuous button several times depends on the current display voltage, current shows that the higher the voltage, the fewer the number of pedestrian.
3. After the voltage adjustment, long press the right button for 2 seconds after the release, at this time to exit the voltage calibration mode, all the parameters set up automatic electricity saving.

Захранващ адаптер с вграден ПоЕ инжектор 24V 1A

   • Output Voltage: 24V
   • Max Output Current: 1A
   • Connector RJ45 LAN
   • Connector RJ45 PoE

DoC - Декларация за Съответствие

Certificate of Compliance
   

POE-24-7W-G-WH е Гигабитов Захранващ PoE адаптер с изходно напрежение 24VDC при 0,3А ток. PоЕ захранване по 2 усукани кабелни двойки - пинове 4, 5 (+) и  пинове 7, 8 (-).

Electrostatic discharge (ESD) is the leading cause for outdoor device failures. You can effectively protect against ESD damage using a grounded Ubiquiti PoE Adapter, TOUGHCableTM, and TOUGHCable Connectors.

• • Surge protection
  • Clamping protection
  • Maximum surge discharge
  • Peak pulse current
  • AC cable with earth ground
  •  
  • СПЕЦИФИКАЦИЯ

Гигабитов ПоЕ инжектор - за захранване на гигабитови рутер бордове MikroTik.

За устройства поддържащи гигабит ПоЕ 9-48V.

Екранирани конектори.

24V  0.8A Захранващ Адаптер

PoE захранващ адаптер, предназначен за  802.3af устройства - 48V 15W.

The 802.3af PoE Injector (U PoE AF) is designed to power 802.3af PoE devices. The U PoE AF delivers up to 15W of PoE that can be used to power the Access Point U6 Lite and other 802.3af devices. It can also provide enhanced protection against electrostatic discharge (ESD).

Features:

• • Delivers up to 15W of 802.3af PoE
  • Compatible with all 802.3af PoE devices
  • Surge, peak pulse, and overcurrent protection
  • AC cable with earth ground
  • Dynamic LED light that indicates device and current status
  • Compatible with TOUGHCable
  •  
  • СПЕЦИФИКАЦИЯ

Захранващ Гиагабитов ПоЕ адаптер с изходно напрежение 24V 0,5A.

Защита срещу пренапрежение и ESD.

Съвместим с Ubiquiti airFiber, airMax и  Unifi PoE устройства.

СПЕЦИФИКАЦИЯ

MT48-480095-11DG is 48 V, 0.95 A power supply. It's part of our GPEN concept, that provides all the benefits of GPON but utilizes well-proven, simple and inexpensive Ethernet solutions.

MT48-480095-11DG allows using long Ethernet cable runs and multiple GPER units - please refer to the table in the last page of GPEN concept brochure in the link below.

GPEN Concept